• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

69 Charger dash removal:

E

Erik Morris

Well-Known Member
Local time
7:04 PM
Joined
Dec 7, 2018
Messages
82
Reaction score
39
Location
Las Vegas, NV
Smoke from the dash the other day indicating something amiss. Would like to remove entire dash and go through it completely. Manual shows procedures to remove trim panel and instrument cluster... figured I should remove dash in it's entirety while I am tearing things down, replace firewall insulation, install hushmat yada yada. Is it possible to get the entire dash out as-is or must the windshield be removed in order to get to all removal hardware?
 
windshield needs to come out to get to the front screws. plus there may be rust hiding under the gasket.
 
LOL .. you're gonna pull the windshield and end up doing a full blown resto - guaranteed !!! Just do the minimum to address the issue and get back to driving the car.

Here's my suggestion. Disconnect the battery. Pull all the connectors off the bulkhead connector in the engine compartment. Make sure all your fuses are good in the fuse block. Now check all pins for "ground" which will indicate a short. Repeat the process with they key in the "on" position.

If this doesn't point to the problem you'll have to poke around under the dash to find the culprit.
 
Basket case said:
windshield needs to come out to get to the front screws. plus there may be rust hiding under the gasket.
Click to expand...
Thank you for the reply. Thinking (and researching) ahead, once the dash is done and the windshield is ready to go back in, are there two seals that are needed or only one? Classic Industries seems to indicate that the following might both be required. One appears custom shaped and the other is a butyl tube. I have not yet removed my windshield as the car is pulling me in numerous directions. Insight?
https://www.classicindustries.com/product/1969/dodge/charger/parts/mb1261.html
https://www.classicindustries.com/product/1969/dodge/charger/parts/k4122.html
 
As I noted in your other thread... the only windshield gasket you want is from Precision Part # WCR-D715
 
dadsbee said:
As I noted in your other thread... the only windshield gasket you want is from Precision Part # WCR-D715
Click to expand...
Wayne why this gasket? I bought one from AMD when I bought the windshield. Just asking because I only want to do this once.
 
Who's did they ship??

Precision because I know it works and was Richard's top recommendation. Steele is probably another...
 
While on the dash topic ...

What about installing the clips on the dash then screwing it in from below - to facilitate future removal without taking the windshield out (should the need arise) ??

From a manufacturing point screwing it in from the top before installing the glass was obviously less labor intensive but since we're not concerned with that ... !!
 
this guy is rough but it give you an ideal in whats involved
 
You must log in or register to reply here.

Similar threads

67charger383
How to remove engine wiring harness 1967 Charger
Replies
2
Views
547
RemCharger
RemCharger
C
Starting work on my Charger
Replies
18
Views
2K
426LVR
4
dspur
Order of Installation- Dash, Hear A/C Box etc
Replies
7
Views
1K
68SS
6
Strykr73
73 Charger Dash Removal
Replies
15
Views
4K
T2R9
T2R9
Ms.Sully
71 RR dash lights
Replies
5
Views
721
71Beeper
71Beeper
Auto Transport Service
Back
Top