'69 Charger door scuff plate screws

[69 Charger]

Hello, Charger-philes. I'm re-installing the interior in my Charger after restoration of the body. Can someone tell me the size (diameter and length) of the countersunk Phillips chrome screws that go into the scuff plates? My recollection is that the screws in the two forward and aft positions are longer than the other four. The original screws were bagged with the plates during storage but have since come adrift (long story). I have a lot of screws salvaged over the years from Chargers in junkyards, but I don't want to do any "rethreading" by trial and error.
Thanks!

 

[Mopar Hunter]

I can’t tell you the size (diameter and length). You can buy them at many places.

Door Sill Plate Screw Set - 68-70 Dodge Plymouth B-Body

www.autometaldirect.com

 

[69 Charger]

Mopar Hunter, thanks so much for your response! With your help, I was able to track down all of the original (to my car) screws. The long ones are slightly different from your photo, since much of the shank is unthreaded on those.

 

[pnora]

Sill Plate Screws 1964-74 Most, Sill Plates/Screws, MP-SP8160 Reproduction, NOS and Used Mopar Muscle Car Parts

 

[oldbee]

Mopar Hunter, thanks so much for your response! With your help, I was able to track down all of the original (to my car) screws. The long ones are slightly different from your photo, since much of the shank is unthreaded on those.

I think the long ones are about 1-1/2” and you’re right; at least 3/4” is a shank, not threaded.