• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Alcohol in gas

Have you tried running fresh gas through the engine (running I mean) ???

Or is this a project on the bench?

:xscuseless:
 
If this is a carburettor on the bench, you could try flooding it with methylated spirits.

That will remove all gasoline type liquids.
 
What are we working on? Car or generator/weed eater/small equipment?

Run the car with ethanol free gas container connected fo fuel pump

Off the engine? Carter turn it upside down and drain it. Holley remove a lower float bowl screw from each float bowl and drain.
 
Last edited:
Alcohol ?
1732636264498.png
 
AAAHHHHH....at the end of a long and trying day......a nice single malt Scotch, double of course, neat, water back or a nice Tennessee Sour Mash Sipping Whiskey......Black Jack Daniel's, the same way, or a blended Canadian, CC or VO......or......????....what ever suits your fancy.......Cheers.....
BOB RENTON
 
1732676887270.png
:bananaweed:
AAAHHHHH....at the end of a long and trying day......a nice single malt Scotch, double of course, neat, water back or a nice Tennessee Sour Mash Sipping Whiskey......Black Jack Daniel's, the same way, or a blended Canadian, CC or VO......or......????....what ever suits your fancy.......Cheers.....
BOB RENTON
 
What are we working on? Car or generator/weed eater/small equipment?

Run the car with ethanol free gas container connected fo fuel pump

Off the engine? Carter turn it upside down and drain it. Holley remove a lower float bowl screw from each float bowl and drain.
I'm that I worded my question poorly. I'm looking to get the leftover crab from the alcohol out of the carburetors. I'm talking about a car and a generator. Is there any way to clean the gunk out without tear down?
 
I'm that I worded my question poorly. I'm looking to get the leftover crab from the alcohol out of the carburetors. I'm talking about a car and a generator. Is there any way to clean the gunk out without tear down?
Has it already turned to gunk in the carburetor? Has some time passed since it was last run, like 3-4 months or more?

If it was recently running then run good gas through it by starting the engine with good gas going in the fuel line.
 
Auto Transport Service
Back
Top