Well thanks for showing the contents of the kit and instructions after... 
Are these Eccentric UCA Bushings?
- Thread starter Moparfiend
- Start date
From this thread in 2013
- Local time
- 12:52 AM
- Joined
- Oct 18, 2008
- Messages
- 3,154
- Reaction score
- 2,456
- Location
- Kindersley,Saskatchewan, Canada
I agreeWell thanks for showing the contents of the kit and instructions after...
The thread taught us something, but it wasn't about bushings.
Sorry guys. I didn’t know the “kit” was different from the original in that it uses washers. I just pulled one of two bags that contained only one bushing each. I didn’t look under the second bag containing the other bushing. At the bottom of the box were the loose washers.
When I pulled the UCA out it was tight. I wonder how adding two washers to each side will change the stack up dimensionally….
When I pulled the UCA out it was tight. I wonder how adding two washers to each side will change the stack up dimensionally….
Ok the bushing is a different dimension from the original. It is smaller/shorter to account for the additional washers. The washers add roughly an 1/8”.
Last edited:
Hey guys, I am looking to get confirmation BEFORE I press in my offset/eccentric bushings. The goal is to increase caster as much as possible. Does this look correct to you guys? Not bushing offset directions left and right.
Note the arrows depict the movement of the UCA from bushing orientation.
Note the arrows depict the movement of the UCA from bushing orientation.
Last edited:
Still wondering if anyone can confirm my eccentric bushing orientation above please. I believe it’s correct but because it’s a one time press fit I just wanted more concurance in the set up. It’s not documented in the FSM but I have read other threads ti get me to this set up.
Thank you,
MF
Thank you,
MF
Vaanth
Well-Known Member
Thank you. Yes I saw this and believe I have it correct. I know the bushings arrows are not really accurate for caster improvement as that was not the original purpose of the kit. Just looking for a thumbs up on my orientation. But Ill go with it as I have set up as it kicks the front of the UCA out and pulls the back of the UCA in which is sort of how it was explained (ball joint to move rearward).
It sounds like you have a handle on it. Get everything orientated properly and mark it with a felt pen, then you're sure , while you're squinting wondering if they're in right lol
Similar threads
