max wedge dimensions?

[barbee6043]

I bought a sheet of 20 ga.( finally after XMas is over with) and I am fabricating the 66-7 hemi scoop, but I also want to try a max wedge scoop also. Can someone send me the basic measurement of the maxie scoop, length, width and height?? The details of where the middle indentions are etc. I promise to post the results of both scoops when done!!
I realize the good repops are only about $200 ( plus postage)! but I want to try this. $34 4 x 8 sheet, and my time, (I work for free on my old Mopars, right!!?). Thanks!!

 

[khryslerkid]

https://www.forbbodiesonly.com/moparforum/threads/correct-dimensions-for-a-max-wedge-scoop.45112/

 

[barbee6043]

Thanks for the help^^^^, I found out all I need. If I like how it all turns out, I will get a sheet of .040 aluminum and try that! The 20 ga. mild steel plate is pretty light though.

 

[Jerry Hall]

I bought a sheet of 20 ga.( finally after XMas is over with) and I am fabricating the 66-7 hemi scoop, but I also want to try a max wedge scoop also. Can someone send me the basic measurement of the maxie scoop, length, width and height?? The details of where the middle indentions are etc. I promise to post the results of both scoops when done!!
I realize the good repops are only about $200 ( plus postage)! but I want to try this. $34 4 x 8 sheet, and my time, (I work for free on my old Mopars, right!!?). Thanks!!

Afraid we all do. Be watching for your results.

 

[georgep3689]

whats your price point? MW scoop?

 

[barbee6043]

whats your price point? MW scoop?

I just at to try my hand at fabbing one out of 20 ga mild steel plate. If I like what I do, I will buy a sheet of .040 aluminum. All I am out now is $35 . Still have the other half of sheet left.
Maybe I am just putting off hanging out the wife's faucet in the kitchen sink!? It is not any fun!

 

[glassman]

I bought a sheet of 20 ga.( finally after XMas is over with) and I am fabricating the 66-7 hemi scoop, but I also want to try a max wedge scoop also. Can someone send me the basic measurement of the maxie scoop, length, width and height?? The details of where the middle indentions are etc. I promise to post the results of both scoops when done!!
I realize the good repops are only about $200 ( plus postage)! but I want to try this. $34 4 x 8 sheet, and my time, (I work for free on my old Mopars, right!!?). Thanks!!

Good repops go for $1600 and originals go for $1500 to $2500 I sell fiberglass for $300-$325