parting out 62-74

[MSBoyd]

Checking to see if you have a set of windshield wiper arms for a 71 Charger.

 

[moparmarks]

Mark,
You have any good usable rocker molding, L & R and front wheel opening molding L & R for a '73 Charger SE car........thanks

I'll check. Should have the rocker moldings.

- - - Updated - - -

Checking to see if you have a set of windshield wiper arms for a 71 Charger.

I'll check. Should have some.

 

[BigFlo]

Looking for trans crossmember '62-65 for A-833.
Also - any chance you might have a vacuum switch for heat/vent control push buttons.

 

[64440belvedere]

Looking for a wiper cowl, doors, front floor section and a passenger side quarter panel for a 65 belvedere two door post car.

 

[74charger07ram]

Do you have a trunk floor and the left and right rear lower quarters for a 74 Charger? Thanks for looking.

 

[camcb]

I need the exterior, rear window sheet metal for my 64 Polara. Specifically the lower corners but would take the whole rear window frame if possible. My car is a 4 dr ht.
Thanks.

 

[PFG MOPAR]

71 Charger ?

Steering column ? w/Wheel ??
Visors? preferably black ?
Seats, console?

lots of other misc parts?

Mike..

:icon_eek:

 

[48dodge]

looking for a pass side rear quarter panel for a 73/74 rr/satellite

Looking for a pass. side rear quarter panel for a 73/74 roadrunner/satellite

 

[nothingbutdarts]

Looking for a 69, Satellite/R. Runner/GTX pass. Ft. fender by chance

 

[moparmarks]

Looking for trans crossmember '62-65 for A-833.
Also - any chance you might have a vacuum switch for heat/vent control push buttons.

Sorry just have some for auto tranny. Also 62 is different than 63-5. Thanks

- - - Updated - - -

Looking for a wiper cowl, doors, front floor section and a passenger side quarter panel for a 65 belvedere two door post car.

Have a cowl and H/T doors right now. Thanks

- - - Updated - - -

Do you have a trunk floor and the left and right rear lower quarters for a 74 Charger? Thanks for looking.

Sorry I don't. Thanks

- - - Updated - - -

I need the exterior, rear window sheet metal for my 64 Polara. Specifically the lower corners but would take the whole rear window frame if possible. My car is a 4 dr ht.
Thanks.

I should have a Dutchman filler panel and the inside package tray for a 64 sedan.

- - - Updated - - -

Steering column ? w/Wheel ??
Visors? preferably black ?
Seats, console?

lots of other misc parts?

Mike..

:icon_eek:

Have some column shift columns. No floor shift ones.
Which steering wheel?
Have some blue visors and bench seats in both high and low backs. No buckets or consoles right now.

- - - Updated - - -

Looking for a pass. side rear quarter panel for a 73/74 roadrunner/satellite

Sorry don't have right now.
Thanks

- - - Updated - - -

Looking for a 69, Satellite/R. Runner/GTX pass. Ft. fender by chance

Sorry no 69 fenders right now.
Thanks

 

[coronet340]

Are the floor pans the same in the 67 Sebring as a 67 Coronet? Do you have one?

And what about the grill frame?

 

[moparmarks]

Are the floor pans the same in the 67 Sebring as a 67 Coronet? Do you have one?

And what about the grill frame?

Satellite and Coronet floors are the same. Just have some of the under rear seat pans right now.
Satellite and Coronet grills are different and I don't have either. Thanks

 

[Mr Belvedere 30144]

65 Belvedere trunk lid?

 

[Shayjoseph]

I'm trying to find the vinyl trim molding for my 71 Satellite. It has the full top. Do you have any of the molding?

 

[moparmarks]

I'm trying to find the vinyl trim molding for my 71 Satellite. It has the full top. Do you have any of the molding?

I'll check but I don't think I do. Thanks

 

[prplcar]

Do you have pics of the 62 Belvedere? I am looking for the lower valance and signal lights. Also some of the trim but have been told it may be different based on Canadian and U.S.A. trim lines.

 

[dsracing01]

Looking for the piece of trim that goes across the hood of a 64 dodge, as well as a good trunk medallion.

 

[camcb]

Could you send me some pics of the Dutchman filler panel?

 

[Auto Teach]

Mark, do you have rear window opening for a 65 b body post car I think 4 door is the same I need the flange area where the gasket would seat I can send you a picture if that helps.Thanks Pete.

 

[rrTor-Red]

Mark:

Wheel lip moldings for 71 RR?