steering pump needed

[dodge71demon]

I sent my TRW/Thompson power steering pump in to get rebuilt and UPS LOST IT.Need pump - housing - pulley for 65 b body I have the brackets or info where I may find one

 

[cudamark]

Which engine do you have?

 

[dodge71demon]

big block (440)

 

[cudamark]

It's hard to tell what will be correct for your application. Your car has been converted so it may be hard to determine what it should have. Do you have a photo of what the old one looked like? I have a couple different early big block pumps but they have different features. The late '64-6 type have the power steering cap with the lugs on the cap where the early '64 and older have the lugs on the reservoir. They also made a hex hole shaft and a plain solid shaft. The hex hole type use a 5 1/2" diameter pulley and the plain end shaft has a 4 13/16' diameter pulley. The offset seems to be the same. I'm not sure if the shaft diameter is the same. I can post a photo if you'd like.
Thanks, Mark

 

[dodge71demon]

it was a 383 then at some point the 440 was installed so I do not see that as an issue.The pump had a plain end shaft

 

[cudamark]

P/S pump

it was a 383 then at some point the 440 was installed so I do not see that as an issue.The pump had a plain end shaft

.......................................................................................................
Here's the plain end shaft type that I have.

 

[chignikred]

pimp

that would be the correct 65 , 66 ps pump. bigblock