water pump nipple wrench?

[wedgee]

Is there a wrench/socket out there thats desiged to take out the heater hose nipples? (other than a vice grip or pipe wrench......)

 

[toolmanmike]

Not that I have seen. You mean the split ones that would take a gigantic screwdriver? Nope. You will probably need to heat the intake.

 

[69L48Z27]

These should work.

MOPAR heater Hose pipe nipple tools fits 1958 - 2003 Dodge Plymouth Chrysler | eBay

 

[eldubb440]

heat it up and melt some wax into the threads

 

[dadsbee]

Internal pipe wrenches. 12 bucks at HomeDepot

https://www.homedepot.ca/product/husky-internal-pipe-wrench-set/1000828290

 

[wedgee]

These should wor

These should work.

MOPAR heater Hose pipe nipple tools fits 1958 - 2003 Dodge Plymouth Chrysler | eBay

k.

MOPAR heater Hose pipe nipple tools fits 1958 - 2003 Dodge Plymouth Chrysler | eBay

and I was just on ebay, hmmm...those will work. thanks

 

[Dave6T4]

I have fought with those, too. What I do, is find a long 1/4" drive socket that fits down inside the nipple, so it will not crush, and take it out with a vice grip.

 

[WileE]

These should work.

MOPAR heater Hose pipe nipple tools fits 1958 - 2003 Dodge Plymouth Chrysler |

All these years, I never knew there were tools for nipples.

 

[wedgee]

Internal pipe wrenches. 12 bucks at HomeDepot

https://www.homedepot.ca/product/husky-internal-pipe-wrench-set/1000828290

bingo!! have one in my plumbing drawer...thanks

 

[wedgee]

thank you all!

 

[eldubb440]

All these years, I never knew there were tools for nipples.

jumper cables

 

[WileE]

jumper cables

I've never put them on nipples. What happens ?

 

[eldubb440]

I've never put them on nipples. What happens ?

probably get kicked in the nuts

 

[R413]

Those pipes been in there for 50 years, you will need a torch and some luck to get them out in one piece.

Put your best tool on it and start pulling, the pipe won't be moving. You will break the tool or the top of the pipe.

 

[WileE]

probably get kicked in the nuts

 

[F4R/T]

Pierced ones with studs may work better for conductivity!
Note: not responsible for accidents or injury.. please read the fine print.

 

[kiwigtx]

Pierced ones with studs may work better for conductivity!
Note: not responsible for accidents or injury.. please read the fine print.

How do you kn..... .....nevermind.

We did this installing into my new engine....

Solutions....not problems.

 

[Demonic]

I have fought with those, too. What I do, is find a long 1/4" drive socket that fits down inside the nipple, so it will not crush, and take it out with a vice grip.

This. Or any round rod that will prevent a 50 yr old fitting from crushing. An 8" Ridgid pipe wrench with a cheater also.

 

[493 Mike]

Make one. Cut off the correct size bolt, drill hole, insert split roll pin.
Mike

 

[toolmanmike]

Make one. Cut off the correct size bolt, drill hole, insert split roll pin.
Mike
View attachment 1692615

I like that idea