what spark plug wires do you guys like for sb strret motor

[ffej]

getting ready to order sparkplug wires and was looking for opinions on what you guys have had good luck with. looking at wires for a built sb. are there any decent ones out there that are made for a sb mopar and fit well? thanks ,jeff

 

[krowbar]

I get universal ones and cut them to length. It helps a bunch when trying to route them around headers.

 

[Rocketman]

I put a set of these on almost every street toy I get, I have never had one fail and like the look.

http://www.summitracing.com/parts/acc-8030/overview/

 

[451Mopar]

I have been using MSD wires for several years. They seem to hold up better than some of the cheaper wires I have used.

 

[67440chrg]

I use msd on my BB and have had good luck with them. I have heard firecore are some of the best.

 

[Photon440]

I used to like Jacob's before they were bought out and off the market.

 

[PoppaSmurf]

Taylor "409" or Thundervolt 50

 

[ffej]

thanks for the replies. are any of these prefitted or an i going to have best luck with cut to fit? the car does have headers thanks again,jeff

 

[bigmanjbmopar]

Not a SB but I have tested 3 different brands and found this, MSD firecore have the lowest resistance value than Taylor, Accel, or Moroso Blue Max all 8 mm tested with fluke ohm meter length for length. Just saying,

 

[ChargerRTguy]

I put a set of these on almost every street toy I get, I have never had one fail and like the look.

http://www.summitracing.com/parts/acc-8030/overview/

X2, I use ACCEL, 8.8 spiral core, pro-stock wires.

 

[451Mopar]

I used to like Jacob's before they were bought out and off the market.

I used to use the Jacobs wires too. Firecore is supposed to be good and correct length for your engine.
I used to have Taylor spiro-pro wires. They worked fine, but did not hold up over time. They have a soft silicone insulation that is fairly easy to tear, and my headers would burn the boots too. I had ignition problems with the low priced Accell Super Stock wires, but that was 30 years ago? I haven't used them since then, but I may try the Extreme 9000 wires on my big block if I have problems burning the MSD vari-angle ends on my headers (so far they seem OK.)

 

[ZombiePopper]

I've used MSD Super Conductor wires on a mild small block (with Thorley headers), the fit was spot on and they looked great, plus they were premade (take em out of the box and plug em in).

 

[Rocketman]

thanks for the replies. are any of these prefitted or an i going to have best luck with cut to fit? the car does have headers thanks again,jeff

the accels were cut and fit

 

[wedge69]

Taylor "409" or Thundervolt 50

X2 !! Best wire we ever ran ! Run Taylor on Everything we run.

 

[PoppaSmurf]

with the Taylor you can get them EITHER way...I do use the PRE-cut on my race engines which are just a little loose, and on my show car I use cut to fit for that tight close fit...along with aluminum wire seperators to keep them high and tight..

 

[Meep-Meep]

A quality brand basic black ones from the parts store. These days it's Prestolite.

 

[ffej]

thanks for all the info now to decide which ones i hate choices