What to do with a lonely engine bay...

[69 GTX]

I would think your combo would make 525-550HP. Pretty close to mine except I have more lift, less duration. And a ported intake. See trick flows on a 440

 

[CudaChick1968]

Does anyone know of an aluminum after market air cleaner?

Mr. Norm had the Tri-Power setup for the '70 Demons. I have one in my parts stash (still unrestored) that could maybe get a new home.

 

[Mike67]

Thanks for the tip Hashmaker, I have the mini starter.... Just wondered how many headaches that I'm looking forward too... I cringed at the thought having to beat them to death to make them fit....I have a motor plate so rocking might be a little tough but I'm sure I'll be able to get it with a lift some 2x4s and a floor jack!!! Thanks again!!!

 

[HT413]

Thanks for the tip Hashmaker, I have the mini starter.... Just wondered how many headaches that I'm looking forward too... I cringed at the thought having to beat them to death to make them fit....I have a motor plate so rocking might be a little tough but I'm sure I'll be able to get it with a lift some 2x4s and a floor jack!!! Thanks again!!!

My flowtech headers were a pain to install, but all in all, straight forward. All I had to do was put the car on ramps, unbolt the Eminem mounts and jack the motor up until the bell housing contacted the trans tunnel. Pull the plugs and snake the old headers out the bottom and bring the Flowtechs up from underneath. No need to pull the cross link, though I bet that would make it easier.