Wheelbase measurement

[bearman]

Got it going to have my relocation kit drilled to move it forward. Just glad I asked before the welding started would have been pissed off trying to drill them on the car and hope it's straight. Thank you for all your help.

 

[bearman]

Okay folks spring hangers I have are the wrong ones. They measure 4 inch from center hole to front of hanger. Relocation kit measurements are 3 inch which should be correct to center rear axle back to stock location. But I think I am still going to drill extra hole at 2 inch just to safe. Also when I move to 3 inch it will put my rear hanger into correct position. Any thoughts

 

[Fran Blacker]

If you have a driveshaft will it be to long by moving rear axle forward?

 

[bearman]

If you have a driveshaft will it be to long by moving rear axle forward?

At this point no drive shaft. Will be one of the last things to do.

 

[Dave6T4]

Did you buy the Dodge hangers meant for '66 and up? If you had bought the Plymouth ones, they are 1" shorter and should fit your ' 64 . If you are using your original bolt up ball and trunion driveshaft there is no allowance there for wheelbase change.

 

[bearman]

I don't know they were on there when I got the car. But dryheat measured his 64 and got me squared up. Kudos to dryheat