Search results for query: *

PM Sent

My son bought a Glock 17. existing: Browning Hi Power Browning Buckmark Ruger Mark 4 Colt 1917 Army 45 revolver Sig something. 9mm Walther 38 military Taurus 40. I forget the mod. Ruger 380 compact High Point 45 I know it's clunky but my daughter can shoot it without hurting her hand. And it's...

So I thought my routing solution was going to work. I sat back, looked at it and realized, close but no cigar. The pipe running under the rail would interfere with the caliper and hose plus some other stuff. My current thinking is to cut through the rails and put a pass through sleeve in[ welded...

And/ or possibly torqued down all in a row. Have seen a few cracked in half

"What I "think" you have are pieces of **** stock rockers that have been overtightened to the point they are now oval. Cut the shafts in half, remove the rockers and get a new, decent set of shafts !!" Agree. Had a set of shafts that were tightened way beyond their 25 ft/lb spec. Lifter noise...

The old standard flat exhaust lobe test is a brief WOT snap, if you get poppoppop the cam is suspect... Strangely with a bad exhaust lobe you can bring throttle in slowly & while the engine may run rough it rarely backfires... But snap the throttle in neutral & you get poppoppop....

Just be honest with them. It's going to suck for while.

None of them need sealer. Some type of antisieze /lubricant perhaps.

The Chrys ign boxes have fixed dwell. Their main advantage is ign timing remains constant for many miles because there is nothing to wear [ points ]; it still uses the inefficient canister coil. GM with HEI introduced varaible/adaptive dwell, that went a long way towards providing maximum coil...

That's why I asked which housing he had.

For me I'd say my 45 caliber, 1911 style, Kimber's. Got 2 of em. 5 & 6 inch barrel lengths.

There's six. Look at a housing gasket, that should tell you which ones could use a sealer. (I'm using elephant ears, so mine are all studded) Drain the coolant, pull the bolts one at a time, seal it, put it back, next.....

Personally, I’ve never had to seal any of them. Never had a leak. Guess you could do them all if you want.

Buy the neighbours a pizza...... I have never run a 30 min break in, more like 10-15 min & under 3000 rpm.

Is your state going to secede from the constitutional USA ?

The Performer will be very limiting with a stroker engine. Edel states the rpm range as idle to 5500. With a stroker, it will be less than 5500; the more cubes, the lower the peak rpm.

What ever happened to "Shall Not be infringed" ???? Said the guy in California..... With our "Roster" our access is limited.... But I do like my Sig P229

Colorado is about to ban the sale of all semi-automatics so it's now or never. I guess I should ask about long guns too. I bought an AR last year and have never fired it. It's a Windham Weaponry. That guy that made Bushmaster sold the company then Bushmasters went downhill hard. After the...

I watched that movie at the theater when it first came out in 1985, and have watched it many times over the years. Have to love Eric Master's girlfriend Debra Feuer. Tom

The nice thing is both the 741 $ 742 use shims to set bearing preload... So you can swap the yoke without effecting the bearing preload... 7290/1330/1350 all are an easy swap... 489 uses a crush sleeve so swapping the yoke can be a problem... To do it right you need to disassemble the axle...