Sorry if this has been asked. Couldn't find the spec anywhere. I'm assuming it's 3.000" based on measurements I took but all seemed about 3.002" or higher. Highest being 3.0032". Any thoughts appreciated!
360 main bore size
- Thread starter Bhealey
- Start date
Funny, I was doing an align hone today on one... 3.0025" to 3.0030"
Awesome! Thanks for the info. Where did you find this spec if you don't mind me asking. I searched everywhere for it... Is there a good book with all mopar specs for future reference?
I have a spec program, but you should be able to look the bearings up on Mahle/Clevite, Federal Mogul, or even rock auto and they will give the specs as "Bearing OD or Bore size".
Similar threads
