A-100 Axle in a 65-body

[moparsrul]

Does anyone know the track width of the A-100 axle compared to the stock track width of a 65 Plymouth Belvedere? I heard they need to be cut and that they are the same? I'm also looking for a good brake source and king pins exc. I would rather go this route in my altered wheelbase 65. I want to get rid of the relocated k frame. Thanks for the post!

 

[440Coronet500]

Take a look at Speedway Motors. They carry alot of kits and components. 440'

 

[POMONAMISSEL]

wasn't landy dodge the first one to go that route , with an a i beam axle from a wagon a100 van . legal equipment because it was called a wagon that hauled people . there should be a few write ups on that car in hot rod , super stock mags , ect.....

 

[69a100]

My 2 A-100 sales brochures I have show that the track from the center of each tire is 60.1 inches, hope this helps? I can't help you on the belvedere info.

 

[moparsrul]

Take a look at Speedway Motors. They carry alot of kits and components. 440'

Yes I had a 65 dart with one it was a super fun car and drove well with a small block. I just don't like the look of there narrow springs and tube axle. The I- beams look out of the day and I want to run wider and longer springs for a better ride.

 

[moparsrul]

wasn't landy dodge the first one to go that route , with an a i beam axle from a wagon a100 van . legal equipment because it was called a wagon that hauled people . there should be a few write ups on that car in hot rod , super stock mags , ect.....

Good point I will check into that.

 

[moparsrul]

My 2 A-100 sales brochures I have show that the track from the center of each tire is 60.1 inches, hope this helps? I can't help you on the belvedere info.

Thanks I will measure that tonight.