Clutch bell crank bracket location on a 69 Charger

[Stucat]

Looking on converting my 69 Charger to a 4 speed. Have all the parts, but need info on locating the clutch bell crank bracket. The engine is not installed so I have plenty of room to work. i found the bracket, but no measurements on location included. Thanks for all the help.






looking on converting

 

[69hemibeep]

Looking on converting my 69 Charger to a 4 speed. Have all the parts, but need info on locating the clutch bell crank bracket. The engine is not installed so I have plenty of room to work. i found the bracket, but no measurements on location included. Thanks for all the help.






looking on converting

Looking at the inner fender and frame at the access hole there is a notch in the frame that a new weld in bracket tab will fall into if the frame hasn't been modified. Iv'e done a couple of them.

 

[radical rob]

Go hydraulic and forget trying to weld to the frame and hope it all lines up even with the bellhousing

 

[Bird 426]

They have their issues too, plus the price.

 

[Stucat]

thanks for all the insight going with the original setup , have all the parts. And yes over a grand for all the parts. Looks like a 10 minute job to put the bracket in. Thanks

 

[Dan Brewer]

Here are some additional pictures for reference.
1966-1970 B-BODY & 1970 E-BODY FRAME BALLSTUD BRACKET - Mopar A833 4-Speed Transmission & Component Specialists

 

[radical rob]

Good luck getting it all in. For me a 10 minute job turns into all day and 3 trips to the hardware store. May it go smoother for you. Please post some pics and commentary to help the next member that wishes to do this.