Rear bracket that the fold up license plate holder mounts too

[hpg4815]

This is what I mean

View attachment 1767168View attachment 1767169


Did you tried with light assembly in place?

73/74s (or at least those 73/74 I have worked on) doesn’t have that extra surface on license bracket, so I can install without deal with the light.

The only difference is try to fit with or without light in place. That’s all.

I am not seeing how adding the light assembly first is going to allow the one I have fit

 

[Nacho-RT74]

71beeper is RoadRunner… diff bracket (and bumper)

 

[Nacho-RT74]

I am not seeing how adding the light assembly first is going to allow the one I have fit

Backwards… first license plate bracket… then after that, the light… will overlap that extra surface on license bracket

 

[hpg4815]

Backwards… first license plate bracket… then after that, the light… will overlap that extra surface on license bracket

I tried to put I on with the light bracket it off and the license plate bracket hangs past the bottom of the bumper

 

[Nacho-RT74]

Tab provisions or bracket could be bent?

All what I can say is how is made the assembly. Now, dealing with used abused parts (or new bad repros) on a tight areas can be tricky. Hard to say from the distance

 

[w.Hudson]

Is this what you need ?

 

[hpg4815]

Is this what you need ? View attachment 1767173

no. that is the front bumper license plate holder. thanks though. looking for the rear

 

[Nacho-RT74]

BTW, the one you removed is exactly the same to the one you bought.

 

[w.Hudson]

no. that is the front bumper license plate holder. thanks though. looking for the rear

I wasn't sure what it fit. It is new and came with some 74 B body stuff

 

[hpg4815]

BTW, the one you removed is exactly the same to the one you bought.

actually it is not. if you look closer you can see there are tab cut outs. similar but definitely not the same.