WTB WTB - Plastic headlight bump outs

[TT from NH]

I accidentally broke the plastic bump out/spacer for the headlight in my 68 Coronet. I can buy a used complete set of 8 with other hardward for $35 (including shipping) on eBay (1968 dodge coronet headlight hardware plastic bump out pegs spacers grille 68 | eBay) but I only need one or two. Anyone have a spare laying around?

 

[MWbirdLOVER70]

See if you can buy two at a bodyshop

 

[RemCharger]

Some c bodies around then had them

 

[moparsaver]

I accidentally broke the plastic bump out/spacer for the headlight in my 68 Coronet. I can buy a used complete set of 8 with other hardward for $35 (including shipping) on eBay (1968 dodge coronet headlight hardware plastic bump out pegs spacers grille 68 | eBay) but I only need one or two. Anyone have a spare laying around?

@moparmendy

Want to sell TT from NH 1 or 2?

 

[RemCharger]

Lol
Post in thread 'Rivets in fenders?' Rivets in fenders?

 

[TT from NH]

See if you can buy two at a bodyshop

Good suggestion. Thanks!

 

[EARLY B]

What is the length you need?

 

[TT from NH]

What is the length you need?

Sorry for the delay; I’m out of town and will get you a measurement by week’s end. Thanks!

 

[TT from NH]

It looks like the spacer is 1 1/8" long.

 

[TT from NH]

Sorry for the delay; I’m out of town and will get you a measurement by week’s end. Thanks!

@EARLY B I wasn't sure if you saw my answer to your question. Thanks for any help you can give. Terry

 

[EARLY B]

use this number for a photo reference@EARLY B I wasn't sure if you saw my answer to your question. Thanks for any help you can give. Terry

Try Restoration Specialities call 1-814-467-9842 use part #8420 as your descriptioin and then tell them the length you need. Or you can go to webb site and search. Part # 8420 is too short. You could also use this part by cutting and epoxy two pieces to gether to get the correct length.

 

[TT from NH]

Try Restoration Specialities call 1-814-467-9842 use part #8420 as your descriptioin and then tell them the length you need. Or you can go to webb site and search. Part # 8420 is too short. You could also use this part by cutting and epoxy two pieces to gether to get the correct length.

Thanks for the suggestion. The part looks pretty simple to fabricate so I might just do that.

 

['68 Charger]

I have all of this from my tub. The long ones are 1" in length.