Search results for query: *

Even at 2500 RPM, no load conditions are greatly affected by the idle circuit in the carburetor. You could lean it out some easily with the idle mixture screws. Secondly, if you haven't done it already, an electronic ignition conversion with a more powerful coil can better burn the fuel you're...

You may want to chronicle this build in the Members Restorations section.

Subscribed! Lots I can relate to here.

In a cavern, in a canyon, excavaaaaaaating for a meme...

When I swapped my '95 Grand Cherokee AT to MT, I had my front drive shaft shortened and a new rear made up. That was $500. I may have had it done at the same place you shopped, as I was in NJ at the time.

Look at Turbo Dodge "D-Valve".

Ghostrider, if you give consideration to the works of Zecharia Sitchen, your statement makes a lot of sense; even offers a "why" go through all that trouble to build such an elaborate complex. Key words: Marduke, interplanetary interactions, massive and immediate polar shifts, "Noah's" Flood.

I'm getting 60 PSI at idle with my 4.6 stroker and Melling stock oil pump. (60-ish miles on the engine so far.)

I have the 12-hole Ford units marketed for 4.0 upgrades. From memory, they flow about 2 lbs/hr more than stock. Compression is 10.5:1. I loaded it with 91 octane before the swap -- just for safety's sake -- and haven't driven it much beyond the break-in.

And the stroker is installed. Holy clydesdales does this thing ever pull... up to about 3800 RPM. It's like the stock 4.0 with about 5-6 Psi of boost.

You'll find a goldmine of info at Category & forums listing - The Forward Look Network. Awesome find, and best of luck with it. Had a '59 Imperial for a couple years.

I bought the crank (new), pistons, rings, & bearings from Scat. I reused the 4.0 rods. There are a few stroker combos that have worked; some using 4.0 rods, some 4.2 rods, different pistons, some with new crank, some with resurfaced 4.2 used stuff. Check out Jeep Strokers - Homepage

My 4.6 Stroker is 1 gasket and 2 M4-0.7 bolts away from ready to install. A bunch of sand blasting & powder coating in this shot.

There are kits to convert used freon tanks into air tanks. Almost free??

Did you know Alfalfa (The Little Rascals) died from a gunshot wound from a dispute over money? He was 31

The only African country that doesn't celebrate Independence Day is Ethiopia. It is the only African country not to be colonized. They successfully defeated Italy at the battle of Adwa.

Oklahoma's state vegetable is the watermelon. Oklahoma State Vegetable: Watermelon

I've seen where classy cars with totally rusted undercarriage were sat on 4X4 truck chassis. Gives you a full frame and fresh suspension with minimal work and money. Mike from NY had a '72 he put on a Ramcharger chassis. Met him at Carlisle probably 25 years ago.

Postponed till Monday, partly due to holiday traffic, partly due to other things.

The current plan is to leave Wednesday, July 3 for NJ. I have a friend in MD that is willing to temporarily store 2 cars and some stuff. I'll be driving to North NJ, picking up stuff, going to MD twice, then returning back. Subsequent trips should be from OK to MD (DC area) and back, with no...