shovelluv
Well-Known Member
Factory built 1970 383 big block. last fall i replaced my carb with a edelbrock 650 tunder series. tuned it in great until it gets hot out. After it sits, when warm, ill take the air cleaner off and i can see the fuel dumping into the intake. I installed the spacer edelbrock suggested but its still boiling when warm. From what ive been reading i can....1) lower the float level 2) block off the intake heat passage in the middle 3) buy a holley. I was wondering if anyone else had this problem with the edelbrocks and how is it fixed?