What did you do to your Mopar today?

[Mocajava]

A RED letter day for me! Got her blasted yesterday and the rebuild starts...after I protect the bare, clean new metal.

 

[mmissile]

excellent.

 

[67 Mopar]

Both torque boxes are now officially installed. One step closer to the finish line...

 

[gyxffyg]

I found the build sheet bolted to the floor of the car under the carpet with one of the bucket seat floor bolts going through the middle of it. Also took it for a short ride to the gas station. Pretty good day.



View attachment 313229

 

[Riverdawg]

Yesterday, it was warm enough, about 55, so I was able to remove a little more undercoating & scale. Slow tedious stuff.

More of the same. Have the trunk area about ready to put the fuel tank back in.

 

[lewtot184]

orphan?

i've been putting this together. not sure what i'll do with it.

 

[djais1801]

washed the blue off the RWL and drove her to the bar I work at.

 

[Brandy]

Sliced off the portion that I needed, to fix the left corner, from the section I got from YY1 and trimmed and welded it together. Now both sides match.

 

[the mississippi madman]

My factory shifter was broken so I rigged this Hurst lever on it so it will work

 

[conv67bdere]

Got a couple things done . . .

Got a bunch of the bare metal into epoxy primer . . .

The firewall - engine side . . .

View attachment 314894

The firewall - driver side in the car . . .

View attachment 314895

Passenger side - inside the car . . .

View attachment 314896

And got my brackets to support my bucket seats tacked in place under the car too . . .

View attachment 314892

 

[djais1801]

felt a little patriotic today...

 

[67 Mopar]

Installed the new cable covers this morning... I nearly forgot about those dang things.

 

[ozymaxwedge]

Pulled the 440 out of my sons Aussie Valiant last night, has run 11.2 but that is just too slow for him Going to step up the cam to a Comp 650 I have and the 3500 converter is coming out for a new 5000.

Tonight working on a mates 440 / trick flow head build.


Might spend some time with the wife Friday night, but wait,,, I have a friend coming to visit for a few days

 

[mmissile]

spending money. just sent another payment on a new car/project.

I've been informed.....NO MO cars, till stuff leaves here!

 

[Daly]

Painted the grille Silver, I wasn't digging the Black...

 

[mmissile]

Buyin' parts. My wife didn't mention a limit on those.

 

[gdrill]

Metal repair.........











View attachment 315871

View attachment 315872

View attachment 315873

View attachment 315874

View attachment 315875

 

[rakort]

http://www.forbbodiesonly.com/moparforum/showthread.php?89663-68-GTX-Project/page3

Been cranking out some work on the 'X

 

[kiwigtx]

Buyin' parts. My wife didn't mention a limit on those.

It's all in the fine print. :rolling::rolling:

 

[conv67bdere]

Getting ready for bodywork . . . stripping the panel down to bare metal . . .

Got most of the major metal work done on the car, now it's time to start on the bodywork . . . got this panel stripped down to bare metal, and I'm working on some of the welds to get them smooth, dilling in some pin holes that I'm finding, and hoping that it'll be smooth enough to aid in the bodywork . . .

View attachment 315909

So far . . . so good . . .