Updating the Super Street Mopar

[ckessel]

No major issues, just getting the fit as good as I can. Not quite hugging the floor around it but some other that is the Nutserts not being flush with the metal they are installed in. Sit up close to an eight. Could buy some dies from Hammer Fab so they don't stick up but those are spendy. Add in the trunk floor above the frame rails isn't perfectly flat. Can't do the hammer/dolly routine to flatten out. So I got it as good as possible. I had an idea about finding some door edge guard material, U shaped, to slip over the edges of the cover. Will mess with that later.
Riv Nut Recess Dimple Die Set - 4 Piece

 

[ckessel]

While I'm waiting for the 3" pie cuts, I trimmed down one of the straight reducers in preparation then removed the mufflers from the pipes. Lighten up the load some while I work at fitting pieces up.

 

[ckessel]

The 3" pie cuts came in today. Came up the a good combination on the lh reducer. Used some duct tape to help hold the pieces together then tacked it together. Went to the rh side and it looks like I need to cut the collector and put at least one pie cut in to get the ball started on that side.